Draft a variable-rate lime plan from the grid soil tests
Acid soil costs yield quietly, and a flat lime rate wastes tonnes where pH is fine while under-treating the worst patches. Grid results come back as a spreadsheet of numbers that nobody turns into a map.
The Variable-rate mapper maps pH by grid point and depth, builds lime zones, applies the rates your agronomist sets for each zone and shows tonnes against a flat rate.
- When · Scheduled
- Early summer, once grid soil pH results are in and before lime spreading is booked
- You get
- pH maps by depth; lime zones with hectares; tonnes needed against a flat rate; plan held for agronomist sign-off before export
- Approval level
- Recommend. Suggests an action. You do it. You can change it.
What it reads
- Grid soil test results: pH at 0 to 10 cm and 10 to 20 cm
- Paddock boundaries and grid point locations
- Past lime applications by paddock
- Lime price delivered and spread
What you get
- pH maps by depth for each paddock
- Lime zones with hectares
- Tonnes needed against a flat rate and the cost difference
- The plan sent to your agronomist for rates and sign-off
When it stops and asks you
- Some grid points are missing results
- Lime was spread in the past two years and may not have worked in yet
- The subsurface layer is acid but the topsoil is fine
How often
Once a year, in summer before lime goes out
Who uses it
OwnersAdvisors and consultants
On other farms
- Mixed: Pasture paddocks often get less lime per hectare, so the plan keeps cropping and pasture paddocks apart.
What it uses
Photos, PDFs and spreadsheets
Send in scale exports, scan results, soil tests, old spreadsheets or a photo of the shed whiteboard, and they become records.
Soil test labs
If we get access, soil results would go straight from the lab into each paddock’s record.
The last 2 make it better, but it works without them.
Nothing official leaves the farm without your yes.This job runs at Recommend: suggests an action. You do it. You can change that any time.
The conversation
How the job plays out, step by step.
3 agents on it
Started 6:00am · Scheduled
- Start to done
- 3 min
- Agent actions
- 7
- Needed you
- 1×
[AGENT NAME]For the Variable-rate mapperOn schedule · 6:00am
Grid soil results for Paddocks 2, 5 and 6 are in; lime spreading not yet booked

Variable-rate mapper → Soil health tracker
Check grid results against past soil tests for Paddocks 2, 5 and 6

Variable-rate mapper
Mapped pH by depth and drew lime zones

Grid results are mapped. The subsoil is worse than the topsoil, especially on the western half of Paddock 5. I’ve drawn 3 lime zones: 120 ha that needs the most, 140 ha middle, 50 ha that’s fine. Rates are [agronomist]’s call. Send it to them?
[AGENT NAME] · 6:00am
Yep, and ask them to price it against a flat 2.5 t.
You · 6:02am

Variable-rate mapper
Sent the zone plan to the agronomist with the flat-rate comparison asked for


Variable-rate mapper → Agronomist
VR lime zones for Paddocks 2, 5, 6 with pH maps; set rates per zone; compare with flat 2.5 t/ha
Done · 6:03am4 saved
- pH maps by depth for each paddockSaved
- Lime zones with hectaresSaved
- Tonnes needed against a flat rate and the cost differenceSaved
- The plan sent to your agronomist for rates and sign-offSent
Behind the scenes
6:00am
Trigger On schedule
Grid soil results for Paddocks 2, 5 and 6 are in; lime spreading not yet booked
documents.read[lab] results, 96 points
6:00am+6 sec
→ Soil health tracker picks it up
Check grid results against past soil tests for Paddocks 2, 5 and 6
6:00am+13 sec
Variable-rate mapper works on it · 3 steps
Mapped pH by depth and drew lime zones
- 0 to 10 cm: 58% of points below pH 5.0 (CaCl2)
- 10 to 20 cm: 71% below 4.8
- 3 zones, 310 ha
6:00am+2 sec
[AGENT NAME] asks for your yes
“Grid results are mapped. The subsoil is worse than the topsoil, especially on the western half of Paddock 5. I’ve drawn 3 lime zones: 120 ha that needs the most, 140 ha middle, 50 ha that’s fine. Rates are [agronomist]’s call. Send it to them?”
6:02am+3 min
You approve
“Yep, and ask them to price it against a flat 2.5 t.”
6:03am+10 sec
Variable-rate mapper works on it · 2 steps
Sent the zone plan to the agronomist with the flat-rate comparison asked for
plans.draftVR lime, 3 paddocksreports.draftpH maps
6:03am+6 sec
→ Agronomist picks it up
VR lime zones for Paddocks 2, 5, 6 with pH maps; set rates per zone; compare with flat 2.5 t/ha
6:03am+3 sec
Variable-rate mapper Done
pH maps and zone plan with the agronomist; nothing exported until rates are signed off
An example with made-up data. Names and figures in [brackets] are placeholders.
The agent behind it
Variable-rate mapperCroppingThe Variable-rate mapper turns yield maps and soil tests into variable-rate seed and fertiliser plans, zone by zone.
What it won’t do
- Set rates without your agronomist’s sign-off
- Send a file to a machine
- Build zones from one season alone without saying so
More jobs the Variable-rate mapper does.
- Draft a variable-rate urea plan for a paddockOn demand
- Find the zones that underperform every yearScheduled
- Price a variable-rate seed plan against a flat rateOn demand
- Check a new yield map is clean before it’s used for zonesDaily
- Check the variable-rate file is ready for the spreaderOn demand
- Check variable-rate zones still fit each paddock’s shapeScheduled
The farm software this job works from
Put [AGENT NAME] to work on your farm.
We’re taking a small number of pilot farms in [REGION]. Start with one or two agents and add more as you go.
See it on a farm like yours.
30 minutes with Thomas, our founder, on records like your own.
Livestock, paddocks, visitors and tanks, in one place.
The farm management software comes with every plan. Keep the software you already use, or use ours.
Not ready yet? Start with a free calculator.
The sums you do every week, for stock, pasture, crops and the books. No sign-up.
Watch a job before you commit.
Pick a playbook and see it play out, step by step.
