Spot a coolroom whose fridge plant is working harder
Fridge plant rarely stops without warning: a low gas charge, iced coil or worn door seal shows up as longer run times for weeks first. Caught early it’s a service call; caught late it’s a room full of warm fruit in January.
The Cool chain watcher compares each room’s run time and recovery after door openings with its own history and raises a job for a refrigeration check before the room fails.
- When · Daily
- The logs you send show a room’s compressor run time or pull-down time well above its usual for the same load and weather
- You get
- Which room, how much harder it’s working and since when; likely causes to check; a job for the refrigeration mechanic once you okay it
- Approval level
- Act with approval. Prepares it fully. You tap yes. You can change it.
- Useful for
- Orchards and vinesMarket gardensNursery
What it reads
- Compressor run time and cycles by room, from logs you send
- Room temperature recovery after door openings
- Outside temperature
- Service history for each room
What you get
- A flag with the room, run time now against usual, and when it started rising
- A short list of the usual causes to check, such as seals, coils and defrost
- A job for the refrigeration mechanic, raised with your yes
When it stops and asks you
- The room’s load changed a lot, such as being filled from empty
- The rise lines up with a heatwave
- A service was done recently and the readings changed after it
How often
A few times a season
Who uses it
ManagersFarm staff
What it uses
Water monitors and weather stations
Trough, tank and rain gauge readings would start jobs for the team.
Wattwatchers
Power use on pumps and sheds would come in, so a pump that stops shows up as a job.
SMS and voice notes
Text the team, send a voice note or a photo, or forward a message. There’s no new app to learn.
The last 2 make it better, but it works without them.
Nothing official leaves the farm without your yes.This job runs at Act with approval: prepares it fully. You tap yes. You can change that any time.
The conversation
How the job plays out, step by step.
Cool chain watcher
Started 5:40am · Daily
- Start to done
- 5 min
- Agent actions
- 4
- Needed you
- 2×
[AGENT NAME]For the Cool chain watcherDaily check · 5:40am
The logs you sent show the Room 4 compressor running 78% of the hour this week against 55% the same week last month

Cool chain watcher
Checked load, weather and door openings to rule out the obvious

Room 4 is working a lot harder: compressor on 78% of the time, up from 55%, and it takes 22 minutes to pull back after the door opens, used to be 9. Weather explains a bit of it, not that much. Worth a seal and coil check. Raise a job for [refrigeration mechanic]?
[AGENT NAME] · 5:40am
Get Tom to look at the door seal first. Then the fridgie if it’s not that.
You · 5:42am

Raising a job for Tom: check Room 4 door seal and strip curtain, today. Send me the next run-time log and I’ll come back to you tomorrow on the mechanic. OK?
[AGENT NAME] · 5:42am
Yep.
You · 5:45am
Done · 5:45am2 waiting for you
- A flag with the room, run time now against usual, and when it started risingSaved
- A short list of the usual causes to check, such as seals, coils and defrostWaiting for you
- A job for the refrigeration mechanic, raised with your yesWaiting for you
Behind the scenes
5:40am
Trigger Daily check
The logs you sent show the Room 4 compressor running 78% of the hour this week against 55% the same week last month
climate.readRoom 4 run time, from the logs you sent
5:40am+16 sec
Cool chain watcher works on it · 4 steps
Checked load, weather and door openings to rule out the obvious
- Room 4 load similar to last month
- Outside temps 2 °C warmer on average
- Recovery after a door opening: 22 minutes, was 9
records.searchlast service [date]
5:40am+2 sec
[AGENT NAME] messages you
“Room 4 is working a lot harder: compressor on 78% of the time, up from 55%, and it takes 22 minutes to pull back after the door opens, used to be 9. Weather explains a bit of it, not that much. Worth a seal and coil check. Raise a job for [refrigeration mechanic]?”
5:42am+3 min
You reply
“Get Tom to look at the door seal first. Then the fridgie if it’s not that.”
5:42am+2 sec
[AGENT NAME] asks for your yes
“Raising a job for Tom: check Room 4 door seal and strip curtain, today. Send me the next run-time log and I’ll come back to you tomorrow on the mechanic. OK?”
5:45am+3 min
You approve
“Yep.”
5:45am+3 sec
Cool chain watcher Done
Job raised for Tom on the Room 4 door seal; run time trend saved; follow-up set for tomorrow to decide on the mechanic
An example with made-up data. Names and figures in [brackets] are placeholders.
The agent behind it
Cool chain watcherHorticulture & packhouseThe Cool chain watcher keeps an eye on coolroom, controlled-atmosphere and dispatch temperatures.
What it won’t do
- Change coolroom settings
- Make up a reading
- Release fruit that broke the cool chain without telling you
More jobs the Cool chain watcher does.
- Wake someone when a coolroom drifts out of rangeDaily
- A weekly cool chain record for the QA fileScheduled
- Track coolroom temperatures through a power outageDaily
- Check pulp temperatures before the truck leavesOn demand
- Check the controlled-atmosphere rooms every morningScheduled
- Fill a gap in the coolroom log before the fruit in it shipsDaily
Put [AGENT NAME] to work on your farm.
We’re taking a small number of pilot farms in [REGION]. Start with one or two agents and add more as you go.
See it on a farm like yours.
30 minutes with Thomas, our founder, on records like your own.
Livestock, paddocks, visitors and tanks, in one place.
The farm management software comes with every plan. Keep the software you already use, or use ours.
Not ready yet? Start with a free calculator.
The sums you do every week, for stock, pasture, crops and the books. No sign-up.
Watch a job before you commit.
Pick a playbook and see it play out, step by step.


